KINGSTON RAM For PC BUS 1600 DDR3 KVR16N11/8
- JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~1.575V) Power Supply
- VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) 800MHz fCK for 1600Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 11, 10, 9, 8, 7, 6
- Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
เปรียบเทียบราคา KINGSTON RAM For PC BUS 1600 DDR3 KVR16N11/8
KINGSTON (KVR16N11/8) 8 GB RAM PC DDR3/1600
Description
This document describes ValueRAM's 1G x 64-bit (8GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, low voltage, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
Features
JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) 800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C TCASE 95°C
Asynchronous Reset
PCB: Height 1.18” (30mm), double sided component
Specifications:
CL(IDD): 11 cycles
Row Cycle Time (tRCmin): 48.125nc (min.)
Refresh to Active/ Refresh Command Time (tRFCmin): 260ns (min.)
Row Active Time (tRASmin): 35ns (min.)
Maximum Operating Power: (1.35V) = 2.730 W*
UL Rating: 94 V – 0
Operating Temperature: 0°C to 85°C
Storage Temperature: -55°C to +100°C
Power will vary depending on the SDRAM used.
KINGSTON RAM For PC BUS 1600 DDR3 KVR16N11/8 ราคาถูกสุดกดดูที่ร้านค้า
Description
This document describes ValueRAM's 1G x 64-bit (8GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, low voltage, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
Features
JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) 800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C TCASE 95°C
Asynchronous Reset
PCB: Height 1.18” (30mm), double sided component
Specifications:
CL(IDD): 11 cycles
Row Cycle Time (tRCmin): 48.125nc (min.)
Refresh to Active/ Refresh Command Time (tRFCmin): 260ns (min.)
Row Active Time (tRASmin): 35ns (min.)
Maximum Operating Power: (1.35V) = 2.730 W*
UL Rating: 94 V – 0
Operating Temperature: 0°C to 85°C
Storage Temperature: -55°C to +100°C
Power will vary depending on the SDRAM used.
KINGSTON RAM For PC BUS 1600 DDR3 KVR16N11/8 ราคาถูกสุดกดดูที่ร้านค้า
KINGSTON RAM For PC BUS 1600 DDR3 KVR16N11/8
Coming Soon...
Coming Soon...
